ST STM32F405 Reference Manual page 433

RM0090
14 Digital-to-analog converter (DAC)
This section applies to the whole STM32F4xx family, unless otherwise specified.
14.1 DAC introduction
The DAC module is a 12-bit, voltage output digital-to-analog converter. The DAC can be
configured in 8- or 12-bit mode and may be used in conjunction with the DMA controller. In
12-bit mode, the data could be left- or right-aligned. The DAC has two output channels, each
with its own converter. In dual DAC channel mode, conversions could be done
independently or simultaneously when both channels are grouped together for synchronous
update operations. An input reference pin, V
resolution.
14.2 DAC main features
•
Two DAC converters: one output channel each
• Left or right data alignment in 12-bit mode
•
Synchronized update capability
• Noise-wave generation
•
Triangular-wave generation
• Dual DAC channel for independent or simultaneous conversions
•
DMA capability for each channel
• DMA underrun error detection
•
External triggers for conversion
•
Input voltage reference,
Figure 64
description.
V
REF+
shows the block diagram of a DAC channel and
(shared with ADC) is available for better
REF+
RM0090 Rev 18
Digital-to-analog converter (DAC)
Table 74 gives the pin
433/1749
454