Leadshine EL8-EC Series User Manual page 3

Transportation
 Please provide storage and transportation under protected conditions.
 Do not stack the products too high up to prevent toppling.
 The product should be packaged properly during transportation,
 Do not hold the product by the cable, motor shaft or encoder while transporting it.
 The product should be protected from external forces and shock.
Installation
Servo drive and Motor:
 Do not install around combustibles to prevent fire hazard.
 Avoid vibration and impact.
 Do not install products that are damaged or incomplete.
Servo drive:
 Please install in electrical cabinet with sufficient protection from outside elements.
 Reserve sufficient gap as per the installation guide.
 Make sure to have good heat sinking.
 Avoid dust, corrosive gas, conductive object or fluid and combustibles.
Servo Motor:
 Make sure installation is tight to prevent it from loosening.
 Prevent fluid from leaking into motor and encoder.
 Protect motor from impact to avoid damaging encoder.
 Motor shaft should not bear the load beyond the limits as specified.
Wiring
 Participate installation personals should have sufficient training in product installation
safety.
 Please power off and wait for 10 minutes to make sure a full discharge of electricity.
 Servo drive and motor must be connected to ground.
 Connect the cables only after servo drive motor installed correctly
 Make sure the wires are properly managed and insulation layer is not torn to prevent
electrocution.
 Wiring must be correctly connected to prevent damage to product(s)
 Servo motor U, V, W terminal should be connected correctly and NOT connected
directly to an AC power supply.
 Capacitor, inductor or filter shouldn't be installed between servo motor and servo drive.
 Connecting wires or any non-heat resistant components should be put near to heat sink
of the servo drive or motor.
 The flyback diode which is connected in parallel to output signal DC relay must not be
connected in reverse.
!
Caution
Caution
!
Caution
Caution
!
Warning
Warning
!
Caution
Caution
User Manual Of EL8-EC** AC Servo
3