Leadshine EL8-EC Series User Manual page 17

Parts & Connectors
Front Panel
Type-C Data Port
CN6 STO(Safety Torque Off)
CN1 I/O signal
CN2 Encoder #1
CN7 Encoder #2
CN3 CN4 RS485
Communication Port
Holding Brake 24VDC
Power-on indicator light
Main power supply 220VAC
Motor connectors
Protective Earth PE
Including a LED display and 5 buttons. LED display is used to display servo
driver status and parameter settings.
5 buttons：
◀
：To switch between different modes and parameters
M
：Switch between value
▲
：Switch between sub-menus/Increase
▼
：Switch between sub-menus/Decrease
S : Enter
Connect to computer for tuning of servo driver. Parameters of the servo driver
can be modified without connecting to main power supply.
STO connecters. Used for any application requiring STO functions.
I/O signal connection terminals(SCSI-26PIN)
Connect to motor encoder
Connect to external encoder（Supports ABZ incremental encoder only.）
Connect to controller with RS485 interface
BR+/BR- brake terminals
Lights up when servo driver is connected to main power supply. Please do not
touch the power terminal immediately after power off as the capacitor might
require some time to discharge.
L1C、L2C ：Control circuit power supply(Single phase 220VAC)
L1、L2、L3：Main power supply 220VAC
：
Note EL8 series supports 1P/3P 220VAC main power supply
P+,B1,B2: Connect B1 and B2 to use internal regenerative resistor
external regenerative resistor is needed, connect it to P+ and B2
B1 and B2.
U,V,W Motor connector: Connect to U,V,W terminals on servo motor
PE motor earth terminal: Connect to motor PE terminal
Connect to PE of main power supply. For grounding
User manual of EL8-EC***F AC Servo
Description
；
If an
，
disconnect
17