Torque Feedforward - Leadshine EL8-EC Series User Manual

6.8.2 Torque feedforward

Position control mode: Torque feedforward can increase the responsiveness of torque
command,
acc-/deceleration.
Velocity control mode: Torque feedforward can increase the responsiveness of torque
command,
Name
Pr1.12
Range
Activation
Before using torque feed forward, please set correct inertia ratio. By increasing torque feed
forward gain, position deviation on constant acceleration/deceleration can be reduced to close to
0. Under ideal condition and trapezoidal speed profile, position deviation of the whole motion can
be reduced to close to 0. In reality, perturbation torque will always exist, hence position deviation
can never be 0.
Name
Pr1.13
Range
Activation
Low pass filter to eliminate abnormal or high frequencies in torque feed forward command.
Usually used when encoder has lower resolution or precision.
Noise reduces if torque feed forward filter time constant is set higher but position deviation will
increase at acceleration varied points.
Torque feedforward application
Set Pr1.13 to around 50 (0.5ms), then tune Pr1.10 from 0 to bigger values until torque
feedforward achieves better performance. Under constant acc-/deceleration, the position
deviation in a motion will decrease as the velocity feedforward gain increase.
Steps to tuning:
2. Increase Pr1.12 to increase responsiveness but velocity overshoot might occur
during acc-/deceleration.
3. By reducing Pr1.13, torque feedforward would be more effective and vice versa.
Pr1.12 and Pr1.13 need to be tuned to a balance and reduce noise.
decrease position deviation during constant
decrease velocity deviation during constant velocity.
Torque feed forward
gain
0~100
Unit 0.1%
0
Immediate
Torque feed forward
filter time constant
0~640
Unit 0.01ms Default
0
Immediate
User manual of EL8-EC***F AC Servo
Mode PP PV
Default 0
Mode PP PV
0
CS CS
HM
P V
Index 2112h
CS CS
HM
P V
Index 2113h
252