Leadshine EL8-EC Series User Manual page 333

Main Sub
Error
code
82 d
Cause
The status of the error
can be detected
Network port LED
The result status
Solution
Main Sub
Error
code
82 E
Cause
The status of the error
can be detected
Network port LED
The result status
Solution
Main Sub
Error
code
83 0
Cause
The status of the error
can be detected
Network port LED
The result status
Solution
Main Sub
Error
code
83 2
Cause
The status of the error
can be detected
Network port LED
The result status
Solution
Display: "Er 82d"
Error description: No synchronization error
Synchronization is invalid
operation
Single flash
Safe operation
1. Verify if "fatal synchronization error" has occurred.
2. Verify master device synchronization settings
Display: "Er 82E"
Error description: Synchronization cycle time is too short
Master device synchronization cycle time is set to less than 125
microseconds
operation
Single flash
Pre-operation
Verify master device synchronization cycle time
Display: "Er 830"
Error description: Invalid Distributed Clock synchronization settings
Synchronization settings in sync mode are not valid
Safe operation
Blinking
Pre-operation
Verify master device synchronization settings
Display: "Er 832"
Error description: Distribution Clock phase-locked loop failure
Distribution Clock phase-locked loop setting is invalid
Safe operation, operation
Single flash
Safe operation
Verify master device Distribution Clock settings and network
transmission delay
User manual of EL8-EC***F AC Servo
333