Mitsubishi Electric MELSEC iQ-R Series User Manual page 561

Error Error Error name
code (System/
(Hexad axis/axes
ecimal) group)
3498H System MCv_ChangeCycleTrig
gered Instruction Error
3499H System AddOn Memory
Shortage
349AH System Memory Shortage
349BH System Motion Command
Execution at STOP
34F8H System Device/Label
Specification Incorrect
34F9H System FB/FUN Callee
Incorrect
34FAH System Label Temporary Area
Incorrect
34FBH System DI Instruction Nesting
Number Error
34FCH System FB/FUN Call Nesting
Number Error
34FDH System Pointer execution error
Error detail and cause Detection
timing (At
start/
during
control
An error occurred during At start
executing During
MCv_ChangeCycleTriggered operation
because of the following causes.
• "Cycle" is out of range (Detail
Code: 1)
• "ExecutionMode" is out of
range (Detail Code: 2)
• Changed current position is out
of range of software stroke limit
(Detail Code: 3)
• The executing axis status is
incorrect (Detail Code: 4)
• "TriggerInput" is incorrect
(Detail Code: 5, 6)
• AddOn SignalIO has not been
enabled. (Detail Code: 7)
• Other
MCv_ChangeCycleTriggered
was executed in specified
instanceID(Detail Code: 8)
• "Options" is out of the range
(Detail Code: 9)
The related addon memory is At start up
insufficient.
The memory capacity in which When
MCFB instance is created is executing
insufficient. dedicated
instruction
Motion Command Execution was When
executed when it is in STOP executing
status. dedicated
instruction
The device or label that cannot When
be used in the instruction was executing
specified. instruction
The function block (FB) or When
function (FUN) specified in the executing
program does not exist. instruction
The label temporary area was When
used incorrectly. executing
instruction
The number of nesting levels in When
the DI instruction exceeded its executing
limit (16). instruction
The number of nesting levels in When
the function block (FB) or function executing
(FUN) exceeded its limit (32). instruction
• The pointer specified in The When
instruction does not exist. executing
• The usable range was instruction
exceeded when the array
element was specified
dynamically.
Operation at Remedy
error
occurrence
• The FB is not • Set "Cycle" within the
executed. range.
• The execution of FB is • Set "ExecutionMode"
interrupted. within the range.
• Set the value of
changed current
position within
software stroke limit
range.
• Execute when axis
status is "Standstill".
• Check the setting of
"TriggerInput".
• Please enable addon
SignalIO.
• Set "Options" within
the range.
The FB is not executed. Please increase
System.PrConst.Addon_
AddonLibraryName.Ram
SizeMax.
Dedicated instruction is Check setting data.
completed with the error.
Dedicated instruction is Set module to RUN
completed with the error. status.
Program stops/keeps Please check and
Follow the setting below. correct error occurrence
Operation setting at points.
error: Invalid device/
label/buffer memory
specification
The program stops. • Please check the error
occurrence points and
correct it.
• Please write the
program again.
The program stops. Please write the
program again.
The program stops. Please change the
number of nesting levels
(16 or less).
The program stops. Please change the
number of nesting levels
(32 or less).
The program stops. • Please check the error
occurrence points and
correct it.
• Please write the
program again.
22 TROUBLESHOOTING
22.5 List of Error Codes
22
559