Mitsubishi Electric MELSEC iQ-R Series User Manual page 560

Error Error
code (System/
(Hexad axis/axes
ecimal) group)
3491H System
3492H System
3493H System
3494H System
3495H System
3496H System
3497H System
22 TROUBLESHOOTING
558
22.5 List of Error Codes
Error name Error detail and cause
Data Source Target The incorrect target modification
Modification Incorrect is specified in ValueSource.
Calculation Profile Memory capacity that exceeds
AddOn System Memory the
Shortage "System.PrConst.Addon_AddonL
ibraryName.RamSizeMax" was
used.
Calculation Profile An error occurred in internal of
Addon Internal Error calculation profile addon.
Axis Status Incorrect MC_GroupEnable was executed
(When Axis Group is when "AxisName.Md.AxisStatus"
Valid) of configuration axis is other than
"StandStill" or "Disabled".
Axis Group Status MC_GroupEnable was executed
Incorrect (When Axis when
Group is Valid) "AxesGroupName.Md.GroupStat
us" is other than "GroupStandby"
or "GroupDisabled".
Axis Group MC_GroupEnable was executed
Configuration Axis Is in for the axis group in which the
Use "AxisName.Md.UseInGroup" of
configuration axis is TRUE (The
configuration axis is in use in
other axis group).
MCv_ChangeCycle An error occurred during
Instruction Error executing MCv_ChangeCycle
because of the following causes.
• "Cycle" is out of range (Detail
Code: 1)
• "ExecutionMode" is out of
range (Detail Code: 2)
• Changed current position is out
of range of software stroke limit
(Detail Code: 3)
• The executing axis status is
incorrect (Detail Code: 4)
• Other MCv_ChangeCycle was
executed in specified
instanceID(Detail Code: 8)
• "Options" is out of the range
(Detail Code: 9)
Detection Operation at
timing (At error
start/ occurrence
during
control
When Not execute FB.
executing FB
At ready ON The program stops.
At ready ON The program stops.
When Axis The axes group status
Group is Valid does not turn
"GroupStandby"
When Axis Not execute FB.
Group is Valid
When Axis The axes group status
Group is Valid does not turn
"GroupStandby"
At start • The FB is not
During executed.
operation • The execution of FB is
interrupted.
Remedy
Set a normal target
modification.
Please check the
"System.PrConst.Addon
_AddonLibraryName.Ra
mSizeMax".
• Please install the
software again.
• Please write the
program again.
Execute
MC_GroupEnable after
setting "StandStill" or
"Disabled" in
"AxisName.Md.AxisStatu
s" of all configuration
axes.
Execute
MC_GroupEnable in the
status where
"AxesGroupName.Md.G
roupStatus" is
"GroupStandby" or
"GroupDisabled".
Disable the axis group in
use and execute
MC_GroupEnable.
• Set "Cycle" within the
range.
• Set "ExecutionMode"
within the range.
• Set the value of
changed current
position within
software stroke limit
range.
• Execute when axis
status is "Standstill".
• Set "Options" within
the range.