Mitsubishi Electric MELSEC iQ-R Series User Manual page 550

Error Error
code (System/
(Hexad axis/axes
ecimal) group)
1ADFH Axis
1AE0H Axis
1AE1H Axis
1AE2H Axis
1C40H System
1C80H System
1C81H System
1C83H System
1C84H System
22 TROUBLESHOOTING
548
22.5 List of Error Codes
Error name Error detail and cause
Insufficient Current The necessary memory capacity
Position Backup in backup was not secured when
Capacity
restoring current position.
Driver Restoration Data The parameter of connection
Incorrect driver device was incorrect when
restoring current position.
Out of Encoder Ring Encoder Ring counter lower limit
Counter Setting Range value > Encoder Ring counter
upper limit value.
Out of Addition and The value is out of range for
Subtraction Selection CombineMode.
Range
Network Parameter The station No. of slave stations
Error (Total No. of that connected to the network
Stations < Station No.) exceeds the total number of slave
stations that has been set in
"Network Configuration Setting".
Cycle Over Arithmetic processing or other
fixed scan processing is not
completed within the set cycle.
Cycle Assignment The value is out of range for
Incorrect system basic cycle, the first
calculation cycle, buffer memory
refresh cycle, or the value which
cannot be set was specified.
Boot Software File Error The file of boot software is
abnormal.
Saved File Number The saved file reached the upper
Over limit value.
Detection Operation at
timing (At error
start/ occurrence
during
control
When Restoring current
restoring position is not
current completed.
position
When Restoring current
restoring position is not
current completed.
position
At power ON Generating axis fails.
At start Not start.
At power ON The station can not be
connected to the drive
unit.
During The axis in operation
operation decelerates and stops.
At power ON Operates in default
operation cycle.
At power The motion system does
supply not start.
At saving files The files can not be
saved.
Remedy
Please execute soft
reboot after checking the
"System.PrConst.Addon
_AbsSystem.BackUpRa
mSizeMax".
• Please connect
Encoder that
MaxAbsCounter is 2
to the power of n.
• Please change the
Electronic Gear to 2 to
the power of n at
connection driver side.
• Set the values so that
they meet the
following condition:
Encoder Ring counter
lower limit value <
Encoder Ring counter
upper limit value.
Set CombineMode
within the setting range.
Set the station No. of
slave stations that
connected to the
network within the total
number of slave stations.
Please change the fixed
scan interval setting of
fixed scan execution
type program to a larger
value.
Please change the
followings to a lager
value.
• "System.PrConst.Syst
emBaseCycle.Cycle"
• "System.PrConst.Oper
ationCycle[1].Cycle"
• "System.PrConst.Buffe
rmemoryRefreshCycle
.Cycle"
Please set the followings
within range.
• "System.PrConst.Syst
emBaseCycle.Cycle"
• "System.PrConst.Oper
ationCycle[1].Cycle"
• "System.PrConst.Buffe
rmemoryRefreshCycle
.Cycle"
Please install the boot
software again
Please delete all the
saved files.