Mitsubishi Electric MELSEC iQ-R Series User Manual page 564

Error Error
code (System/
(Hexad axis/axes
ecimal) group)
3515H System
3516H System
3517H System
3518H System
3C00H System
3C01H System
3C02H System
22 TROUBLESHOOTING
562
22.5 List of Error Codes
Error name Error detail and cause
MCFB Specification The undefined MCFB exists.
Incorrect
MCFB Execution Error Unable to execute MCFB.
ST AddOn System Memory capacity that exceeds
Memory Shortage the
"System.PrConst.Addon_AddonL
ibraryName.RamSizeMax" was
used.
ST AddOn Internal An error occurred in ST addon.
Error
Hardware Error An error was detected in the
hardware.
Hardware Error An error was detected in the
hardware.
Hardware Error An error was detected in the
hardware.
Detection Operation at
timing (At error
start/ occurrence
during
control
At ready ON The program stops.
When The program stops.
executing
instruction
At ready ON The program stops.
At ready ON The program stops.
During Stops the system.
operation
During Stops the system.
operation
During Stops the system.
operation
Remedy
• Please write the
program again.
• Please check if the
necessary addon has
been installed in
MCFB execution.
• Please check if the
label area which is out
of range has not been
written.
• Please write the
program again.
Please check the
"System.PrConst.Addon
_AddonLibraryName.Ra
mSizeMax".
• Please install the
software again.
• Please write the
program again.
• Please take measures
to reduce noise.
• Please reset the CPU
module, and run it
again. If the same
error occurs again
even after taking the
above, the possible
cause is a hardware
failure of the module,
base unit, or extension
cable. Please consult
your local Mitsubishi
representative.
• Please take measures
to reduce noise.
• Please reset the CPU
module, and run it
again. If the same
error occurs again
even after taking the
above, the possible
cause is a hardware
failure of the module,
base unit, or extension
cable. Please consult
your local Mitsubishi
representative.
• Please take measures
to reduce noise.
• Please reset the CPU
module, and run it
again. If the same
error occurs again
even after taking the
above, the possible
cause is a hardware
failure of the module,
base unit, or extension
cable. Please consult
your local Mitsubishi
representative.