Mitsubishi Electric MELSEC iQ-R Series User Manual page 551

Error Error Error name
code (System/
(Hexad axis/axes
ecimal) group)
1C85H System Event History File
Incorrect
1C86H System Out of Cycle Over Error
Selection Range
1C87H System Label Incorrect
1C88H System Label Memory Shortage
1D80H System Out of Parameter
Range (Axis)
1D81H System Out of Parameter
Range (Axis Group)
1D82H System Out of Parameter
Range (System)
1D83H System Parameter Write-
protected
Error detail and cause Detection
timing (At
start/
during
control
An error was detected in the At updating
event history file. the event
history file.
The value is out of range for At power ON
"Cycle Over Error Selection".
Failed to import the label At power ON
definition.
Label which exceeds the label At power ON
capacity has been defined. At ready ON
Parameter is out of the range. When
executing FB
At power ON
At ready ON
Parameter is out of the range. When
executing FB
At power ON
At ready ON
Parameter is out of the range. When
executing FB
At power ON
At ready ON
Wrote in the parameter which can When
only read. executing FB
Operation at Remedy
error
occurrence
Updating the event • Delete unnecessary
history file stops. files to secure the free
capacity.
• Format Target Drive.
• Delete event history
file.
• Please check the
memory capacity of
Addon
MotionEventHist.
Operates in default cycle Please set the followings
over error type. within the range.
• "System.PrConst.Syst
emBaseCycle.CycleO
verErrorType"
• "System.PrConst.Oper
ationCycle[1].CycleOv
erErrorType"
• "System.PrConst.Buffe
rmemoryRefreshCycle
.CycleOverErrorType"
Interrupts the process to Please write label
import the labels. setting.
Interrupts the process to • Please change the
import the labels. System.Md.LabelMem
oryFreeSize to a
larger value.
• Please check the label
usage.
• [When executing FB] Change the specified
The error of FB turns value of detailed
ON and the operation information parameter
is not executed. within range.
• [At power ON]
Generating axis fails.
• [At ready ON] The
READY signal (OX)
does not turn ON.
• [At FB] The error on Change the specified
FB turns ON and the value of detailed
operation is not information parameter
executed. within range.
• [At power ON]
Generating axes
group fails.
• [At ready ON] The
READY signal (OX)
does not turn ON.
• [At FB] The error of FB Change the specified
turns ON and the value of detailed
operation is not information parameter
executed. within range.
• [At power ON/At ready
ON] The READY
signal (OX) does not
turn ON.
Change to the parameter
The error of FB turns ON
and the operation is not that can be written.
executed.
22 TROUBLESHOOTING
22.5 List of Error Codes
22
549