Sntp Settings; Current Time Settings - Allied Telesis AT-9724TS Installation And User Manual

6-20 SNTP Settings

Current Time Settings

To configure the time settings for the Switch, open the Configuration folder, then the SNTP folder and click on the Current Time Setting link, revealing
the following screen for the user to configure.
The following parameters can be set or are displayed:
Parameter
Current Time: Status
System Boot Time
Current Time
Time Source
Current Time: SNTP Settings
SNTP State
SNTP Primary Server
SNTP Secondary Server
SNTP Poll Interval in Seconds
(30-99999)
Current Time: Set Current Time
Year
Month
Day
Time in HH MM SS
Click Apply to implement your changes.
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch
Figure 6- 58.Time Settings Page
Description
Displays the time when the Switch was initially started for this session.
Displays the current time.
Displays the source of the time settings viewed here.
Use this pull-down menu to Enable or Disable SNTP.
This is the IP address of the primary server the SNTP information will be taken from.
This is the IP address of the secondary server the SNTP information will be taken from.
This is the interval, in seconds, between requests for updated SNTP information.
Enter the current year, if you want to update the system clock.
Enter the current month, if you would like to update the system clock.
Enter the current day, if you would like to update the system clock.
Enter the current time in hours and minutes, if you would like to update the system clock.
74