Connection-Log Events - Allied Telesis AR2050V Command Reference Manual

L C
OGGING OMMANDS
-
CONNECTION LOG EVENTS

connection-log events

Overview Use this command to enable extra logging for indicating the start and the end of
connections passing through the firewall.
Use the no variant of this command to turn off the extra logging of connections
passing through the firewall.
Syntax connection-log events [new|end|all]
no connection-log events [new|end|all]
Default Connection logging is not enabled by default.
Mode Global Configuration.
Usage There are two types of messages you can log: new connections and connections
that ended. You can control the amount of messages you log by choosing to log
either type of message or all of the message types.
Messages contain the following information:
•
•
•
•
•
Example To log all of the new connections and all of the closed connections, use the
commands:
awplus#
awplus(config)#
Related show connection-log events
Commands
Command Version 5.4.7-1.1: command added.
changes
C613-50186-01 Rev B
Parameter Description
new
New connection
end
Connections closed
all
All new connections and connections closed. Default.
time
source and destination addresses (NATed and unNATed)
protocol
source and destination ports (NATed and unNATed)
bytes and packets passed (found in the connection end message)
configure terminal
connection-log events all
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
276