F
C
S
LOW
OMMANDS
SHOW DEBUGGING SFLOW
show debugging sflow
Overview
This command displays sFlow® debug settings for agent operation, and for
sampling and polling on specific interface ports. If no interface ports are specified,
sampling and polling will be applied to all ports.
Syntax
Mode
User Exec and Privileged Exec
Example
To display sFlow debug settings on the agent, and for sampling and polling on
ports 1.0.1 to 1.0.9, use the command:
awplus#
Output
Figure 65-1: Sample obtained for an sFlow agent
To display sFlow debug settings for all ports, use the command:
awplus#
C613-50170-01 Rev B
show debugging sflow [interface <port-list>]
Parameter
Description
interface
The interface information.
<port-list>
The ports for which the sFlow debug settings are to be shown.
The ports to display information about. The port list can be:
• a switch port (e.g. port1.1.12)
• a continuous range of ports separated by a hyphen, e.g.
• a comma-separated list of ports and port ranges, e.g.
show debugging sflow interface port1.0.1-1.0.9
awplus# show debugging sflow interface port1.0.1-1.0.9
sFlow Agent Debug:
Sampling
Port
Debug
-------------------------------
1.0.1
Enabled
1.0.2
Enabled
1.0.3
-
1.0.4
-
1.0.5
-
1.0.6
-
1.0.7
-
1.0.8
-
1.0.9
-
show debugging sflow
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
port1.0.1-1.0.24
port1.0.1,port1.0.1-1.0.24.
Enabled
Polling
Debug
Enabled
-
-
-
-
Enabled
-
Enabled
Enabled
2816