Default Configuration; Configuring The Ntp; Configuring Basic Ntp Functions - Huawei AR150 Series Configuration Manual

Huawei AR150&200&1200&2200&3200 Series Enterprise
Routers
Configuration Guide - Device Management
Figure 5-9 NTP application in VPN networking
CE A
VPN2
NTP Client

5.4 Default Configuration

This section describes the default system configuration and default parameters.
Table 5-2 Default configuration of the device
Parameter
NTP function
NTP
authentication
NTP access
control
KOD

5.5 Configuring the NTP

5.5.1 Configuring Basic NTP Functions

You can configure basic NTP functions to enable devices on the network to synchronize clocks.
Pre-configuration Tasks
Before the basic NTP functions are configured, complete the following task:
l
Issue 05 (2014-01-16)
PE
CE C
VPN1
Default Values
Enabled
Disabled
No access control authority is set.
Disabled
Configuring the network layer address and routing protocol of an interface to ensure that
NTP packets can reach the destination.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
P PE
CE D
VPN1
5 NTP Configuration
CE B
VPN2
NTP Server
98