Table of Contents
Advertisement
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
l
6.2 Configuring the ICMP Test
This section describes how to configure an Internet Control Message Protocol (ICMP) test to
check the IP network connectivity.
6.2.1 Establishing the Configuration Task
Before configuring an ICMP test, familiarize yourself with the applicable environment, complete
the pre-configuration tasks, and obtain the required data. This can help you complete the
configuration task quickly and accurately.
Applicable Environment
An ICMP test has a similar function with the ping command, but its output is more detailed.
Pre-configuration Tasks
Before configuring the ICMP test, configure reachable routes between the NQA client and the
tested device.
Data Preparation
To configure the ICMP test, you need the following data.
No.
1
2
3
4
6.2.2 Configuring ICMP Test Parameters
This part describes how to set ICMP test parameters.
Context
Do as follows on the NQA client:
Issue 02 (2012-03-30)
Supports the flexible alarm mechanism. That is, the upper and lower thresholds are set to
monitor the feature of the tested objects according to their OIDs. When the test result
exceeds the threshold, alarms are triggered based on the preset events.
Data
Administrator name and test name of the NQA test
Destination IP address
(Optional) Virtual Private Network (VPN) instance name, source interface that sends
test packets, source IP address, size of the Echo-Request packets, TTL value, ToS,
padding character, interval for sending test packets, and percentage of the failed NQA
tests
Start mode and end mode
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
142
Advertisement
Table of Contents
