Table of Contents
Advertisement
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
Context
Procedure
Step 1 Run the display nqa results [ test-instance admin-name test-name ] command to view the test
results on the NQA client.
----End
Example
Run the display nqa results command. If the test is successful, the following is displayed.
<Huawei> display nqa results
NQA entry(t, t) :testflag is inactive ,testtype is dns
1 . Test 1 result
6.8 Configuring the Traceroute Test
This section describes how to configure a traceroute test to check the connectivity to each hop
on the network.
6.8.1 Establishing the Configuration Task
Before configuring a traceroute test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the data required for the configuration. This
will help you complete the configuration task quickly and accurately.
Applicable Environment
An NQA Traceroute test can provide functions similar to those provided by the tracert
command, but outputs more detailed information.
Pre-configuration Tasks
Before configuring a traceroute test, configure reachable routes between the NQA client and the
device to be tested.
Data Preparation
To configure a traceroute test, you need the following data.
Issue 02 (2012-03-30)
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
The test is finished
Send operation times: 1
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:10.82.55.191
Min/Max/Average Completion Time: 4/4/4
Sum/Square-Sum
Completion Time: 4/16
Last Good Probe Time: 2010-06-21 15:40:12.6
Lost packet ratio: 0 %
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Receive response times: 1
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
6 NQA Configuration
160
Advertisement
Table of Contents
