Table of Contents
Advertisement
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
6.10 Configuring the TCP Test
This section describes how to configure a Transmission Control Protocol (TCP) test to check
the responding speed of a TCP port.
6.10.1 Establishing the Configuration Task
Before configuring a TCP test, familiarize yourself with the applicable environment, complete
the pre-configuration tasks, and obtain the required data. This can help you complete the
configuration task quickly and accurately.
Applicable Environment
To obtain the time for the specified port to respond to a TCP connection request, you can create
an NQA TCP test instance.
Pre-configuration Tasks
Before configuring the TCP test, configure reachable routes between the NQA client and the
TCP server.
Data Preparation
To configure the TCP test, you need the following data.
No.
1
2
3
4
6.10.2 Configuring the TCP Server
The IP address and number of the port monitored by the server must be identical with those
configured on the client.
Context
Do as follows on the NQA server (TCP server):
Procedure
Step 1 Run:
Issue 02 (2012-03-30)
Data
Administrator name and test name
IP address and port number monitored by the TCP server
(Optional) Destination port numbers of the probe packets sent by the TCP client and
source IP addresses , source port numbers of test packets, interval for sending test
packets, and percentage of the failed NQA tests
Start mode and end mode of the test
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
166
Advertisement
Table of Contents
