Show Multicast-Block Config; Show Versions - Siemens SCALANCE XC-200 Configuration Manual

Configuration
3.1 System
Result
The unicast blocking settings for ports are displayed.
3.1.1.16

show multicast-block config

Description
This command shows the multicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show multicast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If no parameters are specified, the settings for all ports are displayed.
Result
The multicast blocking settings for ports are displayed.
3.1.1.17

show versions

Description
This command shows the version information of the entire system.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
58
Description
Keyword for a port description
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
Enter a valid interface
Configuration Manual, 07/2017, C79000-G8976-C361-06