The "Switch Dcp" Wbm Menu - Siemens SCALANCE X-200 Operating Instructions Manual

Configuration / diagnostics using remote mechanisms
6.3 Configuration using Web Based Management (WBM) and Command Line Interface (CLI)
Syntax of the Command Line Interface
Table 6- 29
Command
info
lldpport [ports] <mode>
Note
With X-200IRT IE switches, only the following settings are possible:
 Port sends and receives LLDP frames.
 LLDP frames are sent but not received.
6.3.5.33

The "Switch DCP" WBM menu

Configuring Discovery and basic Configuration Protocol frames
This dialog allows you to configure the handling of frames of the Discovery and basic
Configuration Protocol (DCP) per port.
The DCP protocol is used to detect nodes in a network and to assign basic parameters such
as the IP address, system name etc. to them.
To allow the logical structuring of networks, the sending of DCP frames can be enabled or
disabled port-oriented on an IE Switch X-200.
Note
The sending of DCP frames can be disabled in STEP 7 using the "End of detection of
accessible nodes" function.
222
Switch LLDP - CLI\SWITCH\LLDP>
Description
Displays the current LLDP
settings.
Changes the LLDP settings for
one or more ports.
The <mode> parameter can
have the following values:
RX - receive only

TX - send only

TX RX - send and receive

D - disables sending and

receiving.
Example:
The command "lldpport 1,2,3 rx"
specifies that LLDP frames are
only received on ports 1-3.
Comment
Administrator only.
Operating Instructions, 12/2011, A5E00349864-19
SCALANCE X-200