Wheel End Oil - JLG sky trak mmv Service Manual

General Information, Specifications and Maintenance
2.13.13

Wheel End Oil

WARNING:
vice or maintenance on this vehicle with the
engine running. Contact with moving parts can
cause death or serious injury.
a. Wheel End Oil Level Check
250
MS21702
1. With the vehicle on level ground, move forward or
backward enough to ensure that the lower edge of
the wheel end fill/drain plug hole (1) is positioned
horizontally.
2. Ground the carriage, place the travel select lever in
the [N] NEUTRAL position, place the neutral lock
lever in the [N] NEUTRAL LOCK position, engage
the parking brake switch and shut the engine OFF.
3. Clean the area around the wheel end fill/drain
plug (1). Slowly remove the plug; pressure may be
present. Check the oil level. It should be even with
the bottom edge of the hole.
4. As required, add oil (see the following chart for oil
recommendations) to bring the level up and even
with the plug hole.
Recommended Wheel End Oil/Temperature
MIL-PRF-2104G Grade 10W30
(Universal Tractor Fluid*)
100° F (38° C)
*John Deere (JDM J20C Hy-Gard)
*Ford/New Holland ESN-M2C134-D (Hydraulic Oil 134)
*Massey Ferguson M-1141 (Permatran lll)
*Chevron 1000 THF
Note: ALWAYS replace used o-rings with new o-rings to
ensure proper sealing.
5. Clean and reinstall the wheel end fill/drain plug (1)
using new o-rings. Torque the plug to 96 lb/ft
(130 Nm).
2.48
DO NOT perform ser-
OT0430
Range
MIL-PRF-2104G Grade 15W40
OM1680
1
b. Wheel End Oil Change
1 000
50
MS21902
OH26701
1. Position the vehicle on level ground and move the
vehicle forward or backward to place the wheel end
fill/drain plug (2) in the six o'clock position.
2
2. Ground the carriage, place the travel select lever in
the [N] NEUTRAL position, place the neutral lock
lever in the [N] NEUTRAL LOCK position, engage
the parking brake switch and shut the engine OFF.
3. Place an Accident Prevention Tag on both the
ignition switch and steering wheel, stating that the
vehicle should not be operated. (Refer to Section
1.5, Accident Prevention Tag Usage .)
4. Clean the area around the wheel end fill/drain
plug (2). Slowly loosen the plug. Hold a receptacle
under the wheel end and remove the plug from the
wheel end.
5. Allow the oil to drain completely into the receptacle.
Transfer the oil to a container with a cover and label
the container as used oil. Dispose of used oil at an
approved recycling facility.
6. Reposition the vehicle so the oil level line is placed
horizontally (1).
OT02802
OT0450
OT02902
Model MMV Rev. 12/04