Mirrors - JLG sky trak mmv Service Manual

3.6

MIRRORS

3.6.1 Mirror Location
The vehicle is equipped with three rear-view mirrors.
These include two cab-mounted mirrors; one on the left
(20), another on the top right (21), and an engine hood
mounted mirror (22).
Keep the mirrors clean for optimal operator performance.
3.6.2 Mirror Replacement
WARNING:
glass can cause cuts. Handle a cracked or bro-
ken mirror with care to help avoid personal
injury.
Replace any mirror with cracked glass as vehicle use and
vibration will eventually, if not immediately, cause the
crack(s) to worsen or the mirror glass to fall out.
The mirror mounted on the left side of the cab (20) and the
hood-mounted, convex mirror head (22) are attached to
mirror arm assemblies (23 - hood-mounted) or (24 - left
side of the cab). These mirror heads can be replaced in-
dependently of the arm and mounting hardware.
The hood-mounted mirror arm assembly (23) is secured
to the hood with two M6-1 x 19 mm capscrews (25), M6
lockwashers (26) and 1/4" SAE light flat washer (27).
The mirror (21) at the top right of the cab is secured to the
cab with two #10-24 x 5/8" round-head slotted screws
(28) and #10 lockwashers (29).
The mirror arm assembly (24) on the left side of the cab,
is mounted using a bracket (30). The bracket is secured
to the cab at the top mounting hole using one M6-1 x 19
mm capscrew (31), M6 lockwasher (32) and M6-1
nut (33).
The bottom bracket hole also secures the bottom mirror
arm assembly mounting hole. Use an M6-1 x 19 mm
capscrew (34) and an M6 lockwasher (35) in the bottom
mounting hole of the mirror arm assembly.
The top mirror arm assembly (24) mounting hole is
secured with one M6-1 x 14 mm capscrew (36) and
M6 lockwasher (37).
Model MMV Rev. 12/04
A mirror with cracked
Cab, Covers and Mirrors
22
23
27
25
21
29
28
31
36
37
34
35
26
30
32
33
20
24
MM1781
3.43