JLG sky trak mmv Service Manual page 113

7. Install the rear cab to cab mount attaching hardware.
Install but DO NOT tighten two 3/4-10 x 3-3/4"
capscrews (7), two rebound washers (8) and two
new 3/4-10 elastic locknuts (9). Tap the capscrews
into the cab isolators (4) from below, as required, but
DO NOT distort or damage the cab isolators.
Note: ALWAYS replace elastic locknuts with new elastic
locknuts to help ensure proper fastening.
8. Install the front cab to cab mount attaching hardware.
Install but DO NOT tighten two 3/4-10 x 3-3/4"
capscrews (10) and two rebound washers (11). Tap
the capscrews into the cab isolators (4) from below, as
required, but DO NOT distort or damage the cab
isolators.
6
Model MMV Rev. 12/04
4
5
11
10
9. From behind the cab, position the lower clamp (12)
on the fuel hose (13). Remove any cap or safety
cover from the fuel tank opening. If needed, secure
the fuel filler (20) to the cab and the top end of the
fuel hose (13) to the fuel filler (20).
10. Slip the lower end of the fuel hose (13) onto the fuel
hose neck (14) on the fuel tank and tighten the lower
clamp (12).
11. Route the lower breather hose (15) through the
opening at the rear of the cab and position a clamp
(16) on the hose. Remove any cap or safety cover
from the beaded hose tee (17). Secure the lower fuel
breather hose to the beaded hose tee (17).
12. Position a clamp (18) on the fuel breather hose (19).
Remove any cap or safety cover from the beaded
hose tee (17). If needed, secure the top end of the
fuel breather hose to the fuel filler (20) with another
clamp (21). Secure the bottom end of the fuel
breather hose to the beaded hose tee (17).
13. Reconnect the fuel sender wire (22) to the cab
harness.
9
4
8
15
7
MM2190
22
Cab, Covers and Mirrors
20
21
19
18
16 17
13
12
14
MM4690
3.15