JLG sky trak mmv Service Manual page 103

8. Remove the seat assembly from the seat support
(refer to Section 3.3.2, Seat Replacement ). Remove
the two elastic locknuts and rebound washers from
the rear of the cab and leave the tethers attached to
the seat.
9. On the back side of the cab, clip the two tie wraps
(10) securing the two flexible heater hoses (11) to
the plenum (12).
13
15
10. Loosen both hose clamps (13) securing the heater
hoses (14) to heater valve (15). Disconnect and label
both hoses.
IMPORTANT: Before the cab can be removed from the
vehicle, the air conditioning hoses (16) need to be
disconnected from the heater/air conditioning blower
beneath the seat. This procedure must be completed by
an authorized air conditioning service technician. This
service technician will also need to be available when
the cab is re-installed to re-install the air conditioning
hoses to the heater/air conditioning blower.
Model MMV Rev. 12/04
7
8
9
7
8
SS1230
14
11
12
10
MM4580
16
Cab, Covers and Mirrors
11. Remove two capscrews (17), lockwashers (18) and
rebound washers (19) from the rear of the cab (20).
12. Open the armrest (21) and remove capscrew (22),
lockwasher (23) and rebound washer (24) securing
the rear tool bin (34) to the console support (25).
13. Carefully pry the switch bezel assembly (26) out of
the panel. Label and disconnect the switch wiring
connector(s).
14. Remove capscrew (27), lockwasher (28) and flat
washer (29), securing the rear tool bin (34) to the
side of the cab.
15. Remove capscrew (30), lockwasher (31), and
rebound washer (32), securing the rear tool bin (34)
to the front dash (33).
16. Remove rear tool bin (34).
26
29
28
27
33
22
21
23
24
30
31
32
18
17
25
34
20
19
MT1990
3.5