General Anti-Corrosion; Carriage Fork Shafts And Wear Pads; Paint; Thread Locking Compound - JLG sky trak mmv Service Manual

2.6.9

General Anti-Corrosion

a. Anti-Corrosion Compound
For general anti-corrosion protection, use a wax film
rust inhibitor that provides a protective film two ten-
thousandths of an inch (0.0002" or 0,00005 mm) thick.
One such rust inhibitor that is specifically formulated for
this purpose is LPS 3 . It is marketed by:
LPS Laboratories, Inc.
4647 Hugh Howell Rd.
Tucker, GA 30085-5052 USA
Phone: 1-800-241-8334
Fax: (770) 493-9206
Note: Anti-corrosion protection is especially important in
frame and stabilizer cylinder pin support bores for pro-
tection from fretting corrosion wear.
b. Anti-Corrosion Need Areas
Coat all unplated pins and all bores for cylinder pins,
attachment pivot pins, chain sheave pins, the quick attach
lock pin, and all quick attach lock pin bores. On the boom,
coat the fork shaft and unpainted boom slide pathways.
2.6.10

Carriage Fork Shafts and Wear Pads

Use ONLY Teflon Lube to coat the entire fork shaft (1)
and the wear bar (2). DO NOT apply grease or any other
type of petroleum based lubricant to these areas. Grease
and petroleum based lubricants attract debris which will
prematurely wear the fork bushings and/or wear pads.
Apply Teflon Lube as needed to keep forks sliding
side-to-side smoothly, when putting vehicle into storage
or when Teflon Lube appears to be worn off or rust starts
to appear on the fork shaft or wear bar.
Model MMV Rev. 12/04
General Information, Specifications and Maintenance
2.6.11
Unless otherwise specified, paint components as indicat-
ed in the following sections.
a. Military Paint (CARC)
Durable, premium military paint is available in a produc-
tion-sized one gallon (3,8 liters) container for extensive
repainting. Consult the appropriate parts manual for the
applicable part number and ordering information. Use
military paint on all vehicle components except as speci-
fied in paragraph 2.6.11, b .
b. Black Paint
Durable, premium black paint is available in both a con-
venient 16-ounce (480 ml) spray can for touch-ups, and
in a production-sized one gallon (3,8 liters) container for
extensive repainting. Consult the appropriate parts manual
for the applicable part number and ordering information.
• Boom Angle Indicator Pointer
• Brake Pedal
• Radiator
• Seat Adapter Plate
• Radiator Shroud
• Transmission Oil Cooler
• Drive Shafts
• Transfer Case
• Forks
• Mirrors and Mirror Brackets
1
• Steering Column
• Wheels
2
• Air Conditioner Condenser
OM09402
• Air Conditioner Condenser Guard
2.6.12
For general thread-locking purposes, Loctite
manufactured by Loctite Corporation, are recommended.
Contact:
Loctite Corporation
1001 Trout Brook Crossing
Rocky Hill, CT 06067 USA
Phone: 1-800-LOCTITE (1-800-562-8483)
FAX: (860) 571-2460
Internet: http://www.loctite.com
®
Loctite

Paint

Thread Locking Compound

is a registered trademark of Loctite Corporation.
®
products,
2.23