JLG sky trak mmv Service Manual page 112

Cab, Covers and Mirrors
c. Cab Installation
WARNING:
fuel tank and beaded hose tee openings. Fail-
ure to comply can cause an explosion or fire
hazard, that can result in death or serious per-
sonal injury.
WARNING:
wear with reinforced toe caps and slip-resistant
soles. Failure to comply can result in foot injury
from falling objects or other bodily injury from
slipping or falling.
WARNING:
object without the help of at least one assistant
or a suitable sling or hoist. Failure to comply
can result in death or serious personal injury.
1. Block all four wheels to help prevent the vehicle from
moving. Assure that there is sufficient overhead and
side clearance for cab installation.
1
3.14
Cap or safely cover the
Wear protective foot-
NEVER lift a heavy
3
2
MM2200
2. Attach a clevis (1 and 2) to each of the cab lifting
brackets. Route a sling (3) with a minimum lifting
capacity of 2,000 lbs. (907 kgs.) through the clevis'
to a hoist or overhead crane. Make sure the sling is
centered between the clevis' to ensure even lifting.
3. Install four cab isolators [2-Front and 2-Rear] (4) into
the mounting holes on the cab mount (5).
4. Use a hoist or overhead crane and sling attached to
the cab (6). Carefully begin to lower the cab onto the
cab mount. Stop and check that wiring, fuel tank
components, hydraulic hoses, etc., will not be
pinched or damaged as the cab is lowered.
5. Route the throttle cable from beneath the cab to the
engine compartment by simply positioning the cable
under the frame, then up between the transmission
and engine. Bring the cable across the side of
engine to the throttle cable bracket. DO NOT attach
the cable to the throttle lever extension on the engine
at this time.
6. Carefully and slowly lower the cab (6) onto the cab
mount (5). Align the cab with the cab isolators (4) as
the cab is lowered. Readjust the position of the sling
as needed to help balance the cab during
installation.
Model MMV Rev. 12/04