JLG sky trak mmv Service Manual page 130

Cab, Covers and Mirrors
7. Remove four button head screws (16) and
J-nuts (14) securing the steering column bottom (6)
and top (17) covers onto the steering column (5).
8. Remove two phillips pan-head screws (8),
lockwashers (9) and four spacers (10) securing the
transmission range selector (11) and turn signal/
lights lever (4) to the steering column (5).
9. Remove the transmission range selector (11).
17
16
13
12
11
9
8
1. Horn Button Cover (1)
2. Thin Nut (1)
3. Steering wheel (1)
4. Turn Signal/Lights
Lever (1)
5. Steering Column (1)
6. Steering Column
Bottom Cover (1)
7. Power Steering
Valve (1)
8. Phillips Pan-Head
Screw (2)
9. Lockwasher (2)
3.32
16
10
15
14
10
5
6
7
10. Spacer (4)
11. Transmission Range
Selector (1)
12. Lockwasher (4)
13. Socket-head
Capscrew (4)
14. J-Nut (4)
15. Horn Switch Lead (1)
16. Button-Head
Capscrew (4)
17. Steering Column Top
Cover (1)
d. Transmission Range Selector and
Turn Signal/Lights Lever Installation
1. Position the transmission range selector (11) and
turn signal/lights lever (4) onto the steering
column (5).
2. Attach the transmission range selector and turn
signal/lights lever with two M4-0,7 x 20 mm phillips
pan-head screws (8), two M4 lockwashers (9) and
four spacers (10). Tighten the screws securely, but DO
NOT overtighten. Overtightening will cause the
range selector or turn signal/lights lever to break.
3. Plug the electrical connectors (26) into the harness
1
connectors.
2
4. Install the steering column bottom (6) and top (17)
covers onto the steering column. Secure with four
3
#10-24 x 5/8" button head screws (16) and
J-nuts (14). DO NOT overtighten.
5. Install the lower dash cover (18), and secure using
4
three #12-14 x 1" self-drilling screws (19)(one screw
not visible in illustration).
19
MM4590
6. Connect the negative (-) battery cable (20) at the
negative (-) terminal on the battery in the engine side
battery box.
7. Connect the negative (-) battery equalizer cable (21)
at the bottom of the battery equalizer (22). Torque
the nut to a maximum of 100 lbs/in (11 Nm).
8. Replace battery box cover (23). Use the wing
nuts (24) and carriage bolts (25) to secure the cover
in place.
18
Model MMV Rev. 12/04
MT0120