JLG sky trak mmv Service Manual page 127

21
9. Place the seat support plate (26) back into the cab.
Tilt the plate toward the back of the cab and block up
in this position using blocks of wood or some other
means. Block up far enough to allow you to attach
the two wires to the momentary push button switch
and to tie wrap the wire harness to the tie wrap
mounts as described in the next two steps.
29
28
10. Pull the wire harness (27) back through the grommet
in the rear of the cab. Secure the two wires (28) from
the harness to the terminals on the cold start button
switch (29).
11. Secure the wire harness to the tie wrap mounts
using two tie wraps (30).
Model MMV Rev. 12/04
19
26
20
MM5270
26
30
MM5250
25
24
23
22
12. Line up the four mounting holes in the seat support
plate (31) with the holes in the seat support
base (32). Secure in place using four capscrew (33),
lockwashers (34) and flat washers (35).
13. Replace the seat to the seat base. Refer to Section
3.3.2, Seat Replacement
14. Connect the negative (-) battery cable (36) at the
battery negative (-) terminal on the battery in the
engine side battery box.
15. Connect the negative (-) battery equalizer cable (37)
at the bottom of the battery equalizer (38). Torque
the nut to a maximum of 100 lbs/in (11 Nm).
27
16. Replace engine side battery box cover (39). Use the
wing nuts (40) and carriage bolts (41) to secure the
cover in place.
40
39
Cab, Covers and Mirrors
38
37
36
41
33
34
35
31
32
MM5260
MM2911
3.29