JLG sky trak mmv Service Manual page 111

17
Model MMV Rev. 12/04
58. Carefully begin to lift the cab. Stop and check that all
wiring, fuel tank components, hydraulic hoses and
fasteners are disconnected or removed. If the throttle
19
cable is still attached to the cab, reposition or remove
the throttle cable as necessary.
59. When all wiring (engine, lighting harnesses and all
18
leads from the cab harness), hydraulic hoses and
fasteners are disconnected or removed, carefully
and slowly lift the cab and remove it from the cab
mount. Readjust the position of the sling as needed
to help balance the cab during removal.
60. When the cab is completely clear of the vehicle,
carefully lower it to the ground. Block up or support
the cab so that it does not move or fall. Assure that
no personnel enter the cab while it is removed from
the vehicle.
61. Inspect the condition of the fuel tank, fuel hoses,
fittings, clamps, hydraulic hoses, cab isolators, etc.
Replace parts as indicated by their condition.
62. Inspect and replace other vehicle parts that are
exposed with the cab removed. Repair or replace as
required.
MM2200
Cab, Covers and Mirrors
3.13