JLG sky trak mmv Service Manual page 43

12. Recheck the level of fluid in the transmission with the
engine running at idle.
13. Add oil as necessary to bring the fluid level up to the
FULL mark on the transmission dipstick. Install the
oil dipstick. Recheck the oil level when it reaches
operating temperature (180-200° F or 83-94° C).
14. Recheck all drain plugs, lines, connections, etc., for
leaks and tighten where necessary.
2.12.7 After Tire and Wheel Service
1. Check air pressure.
2. Be sure the lockwashers are properly positioned
under each wheel nut.
3. Check wheel nut torque. Tighten to 430-470 lb/ft
(583-637 Nm).
2.12.8 After Engine Service
Consult the qualified service agent (manufacturer's rep-
resentative and/or service manual) for proper procedures
before engine startup.
2.12.9 After Boom Service
1. Check wear pads.
2. Check chain tension adjustment.
3. Apply grease at all lubrication points (grease fittings).
4. Check for proper operation by operating all boom
functions through their full range of motion several
times.
2.12.10 After Axle Service
1. Check fluid levels.
2. Check torque on drive shaft flange yoke retaining
bolts. Tighten these M12 bolts to 156 lb/ft (212 Nm).
3. Be sure the lockwashers are properly positioned
under each wheel nut.
4. Check wheel nut torque. Tighten to 430-470 lb/ft
(583-637 Nm).
5. Check toe-in if required.
6. Apply grease at all lubrication points (grease fittings).
7. Refer to the axle manufacturer's maintenance
manual for further information.
Model MMV Rev. 12/04
General Information, Specifications and Maintenance
2.27