Cylinder Head Cover Removal; Installation - TOHATSU BFT75A Service Manual

dummyhead dummyhead
Set harness clip bracket B [1] on the chain case, and
tighten the two bolts [2] securely.
Install the tube joint [3] on fuel tube clamp B, and install
the fuel strainer (low pressure side) [4] on harness clip
bracket B.
Install the following parts:
– Alternator (page 7-9)
– Cylinder head cover (page 14-16)
– Engine under cover (page 6-7)
– Engine cover

CYLINDER HEAD COVER REMOVAL/

INSTALLATION

REMOVAL
Remove the following:
– Engine cover
– Engine under cover (page 6-5)
– Under cover rear bracket (page 6-15)
Disconnect the oil tube [1] from the mount case [2].
• Oil leaks out when the oil tube is removed. Catch the
leaking oil with a shop towel and a suitable
container, and wipe up any spilled oil.
CYLINDER HEAD
[2]
[4]
[1]
[1]
[3]
[2]
14-15