Network Settings - Hitachi Compute Blade 2000 User Manual

 Network settings
This screen shows the management network settings of the server blade.
You can set restrictions on the IP address of the network device that can be
connected to the server blade. You can specify up to four IP addresses to allow
connection to the server blade.
# Item
1 Refresh
2 MAC Address
IP Address
Netmask
Default Gateway
DHCP
3 IP address Restriction
4 Permitted IP Address 1-4
5 Reset
6 Modify
Description
Reloads the information.
Shows the network settings of the server
blade.
To set or modify the IP address and netmask,
use the LC Command of the management
module.
For DNS setting, see the DNS Client
DHCP: Dynamic Host Configuration Protocol
Enable or disable the restriction on the IP
addresses.
Enter IP addresses that you allow connection
to the server blade. You can set a single IP
address or subnet in each field.
Ex.
Single IP address: 192.168.10.1
Subnet: 192.168.10.0/255.255.255.0 or
192.168.10.0/24
Cancels the edited settings.
Validates the edited settings and moves to the
confirmation screen.
105
screen.