Hitachi Compute Blade 2000 User Manual page 177

Recovery procedure for server blade web console
connection:
If you cannot connect to the server blade web console or
the server blade web console does not respond for more
than 1 minute when you click a menu item or a button,
follow the recovery procedures described below.
Procedure1 (Check the network):
If there is failure in the network and the Transmission
Checksum Protocol (TCP) connection between the web
browser and the server blade does not operate normally,
the web browser may not connect to the server blade
web console, or the screens of the server blade web
console may not be displayed in the web browser
window.
Also, if the throughput of the network is low, it may take
some time for the screens of the server blade web
console to be displayed.
Check that there is no failure or problem in the network.
If there is no problem or failure, continue to Procedure 2.
Procedure 2 (Restart the server blade BMC):
(1) Log in to the system console of the management
module. See Chapter 6 for the usage of the system
console for more information.
(2) Restart the server blade BMC using the following
command on the system console:
"PC command"-"P. Power control"-
"R.Restart"
See "PC command" in Chapter 6 for information
about the PC command.
The BMC needs a few minutes to restart. Log in to the
server blade web console after the BMC is restarted.
Example of VFP logs
126