Hitachi Compute Blade 2000 User Manual page 136

 LPAR manager boot settings
Configure the LPAR manager boot settings.
Select Server Operation in the upper tabs and then select LP Setup in the tree
menu on the left to display the following screen.
If you do not use LPAR manager, set OS mode to Basic mode, which is the default
setting.
If you use LPAR manager, set OS mode to logical partitioning manager (LP) mode.
#
1 Refresh
2 OS Mode
3 LP Model
4 LP Firmware Version
5 Switch the LP firmware
6 Reset
7 Modify
See 'LP Mode Setting' in "LPAR manager Boot"

in Chapter 12 for more information.
LP Model is displayed only when the BMC

firmware 03-45 or above and LPAR manager
firmware 57-10 or above are installed on the
server blade.
Item
Reloads the information.
Basic mode: Select this not to use LPAR
manager.
LP mode: Select this to use LPAR manager.
Displays the LP model string.
Bank0, Bank1: Displays LP firmware version of
each bank.
Active: shows the firmware bank currently
selected.
Alternate: shows the firmware bank not
currently selected.
When firmware exists, its version is shown.
When no firmware exists, "N/A" is shown.
Selects which bank (Bank0 or Bank1) is to be
used for next LPAR manager boot. Switching
banks is executed at the next power-on or
reset.
Cancels the edited settings.
Validates the edited settings and moves to the
confirmation screen.
85
Description