Hitachi Compute Blade 2000 User Manual page 151

(*5) This item is available with X55R4.
(*6) If the BMC firmware version is 03-77 or earlier, the default value of this item is PCIe
Error Isolation. If the BMC firmware version is 03-78 or later, the default value is
Legacy.
(*7) To use these settings on the server blade X55A1/X55A2 model, BMC firmware
version 03-77 or later must be installed in the server blade.
(*8) The UEFI boot can be set only when Windows Server 2012 or later is booted from the
Hitachi 8 Gb fibre channel (PCI card/expansion card) or Hitachi 16 Gb fibre channel
(PCI card). For Hitachi 16 Gb fibre channel, firmware version 11-40/12-40 or higher is
required.
Setting item
Other PCI Device ROM Priority
For other boot devices and OSs than those shown in (*8), use the default value.
(*9) Set the following only for PXE boot.
Setting item
PXE Option ROM Execution
Policy
PXE LAN1 Option ROM Scan
PXE LAN2 Option ROM Scan
Network Stack
IPv4 PXE Support
IPv6 PXE Support
See Selecting
For UEFI boot with PXE boot, firmware version 11-40/12-40 or higher is required
(*10) Use the default value.
The edited EFI settings will be enabled on the next power
on or reset.
When you use the remote FD or remote CD/DVD

as a boot path, start Remote Console Application
and start the remote FD or remote CD/DVD
before you power on the server blade.
You can display/hide the toolbar of Remote

Console Application (Reclient) by pressing Alt+G
keys.
For details about Remote Console Application,

see the Remote Console Application User's
Guide Hitachi Compute Blade 2000 in the CD
attached to this equipment.
UEFI boot
UEFI Option ROM
UEFI boot
UEFI only
Enable the LAN you
use.
Enable
Set to Enable
depending on your
LAN environment.
PXE booting
100
Legacy boot
Legacy Option ROM
Legacy boot
Legacy only.
Enable the LAN you
use.
Only for UEFI boot:
Set the default value in
Legacy boot.
Only for UEFI boot:
Set the default value in
Legacy boot.
for details.