Turn The Power On Or Off; Turn On The Power - Hitachi Compute Blade 2000 User Manual

Turning power on or off
This section describes how to turn on and off power to the system equipment.
Follow the prescribed procedure for power operation. Powering on or off not
according to the prescribed procedure can cause equipment failure.
After turning off or on the power to the system equipment,
wait at least 10 seconds before turning on or off the power
again.
Turn on power
1 Turn on power to peripheral equipment, such as a storage unit.
Some peripheral devices may need to be turned on before
the system equipment is turned on. For details, see the
manuals for those peripheral devices.
2 Open the rear door of the rack cabinet, and connect the power cable of the
alternating current (AC) power input module to the power outlet.
The POWER LED of the power supply module blinks.
See the Instruction Manual that came with the rack cabinet. This is often located
inside the front door of the rack cabinet.
3 When the POWER LED on the front panel stops blinking and lights solid orange,
press and hold the power switch of the server blade for one second or more.
When the N+M cold standby function is enabled, the power LED on the front panel
lights solid orange, Smart Configure is automatically executed, and then the status
LED: condition lamp (CND) on the server blade lights solid green. Confirm that the
power LED of the front panel lights solid orange to show Smart Configure is
complete before pressing the power button of the server blade for a second or
more.
NOTICE
NOTICE
70