Connect The Power Cables - Hitachi Compute Blade 2000 User Manual

Connect the power cables

Do not connect multiple power cables to a single electrical outlet. Overheating the
power cables or outlet could cause a fire and trip the circuit breaker, which affects
other devices on the same circuit.
When unplugging a power connecter, wait 10 or more seconds before reconnecting the
power cable because the system equipment may not boot.
Provide one circuit on the branch circuit in the

distribution panel with one outlet. Do not connect
any other electrical device to the branch circuit to
which this equipment is connected.
Use a fuse free breaker (FFB) to equip with the

distribution circuit panel as a circuit breaker.
The number of power outlets National Electrical Manufacturers Association (NEMA) L6-
30R (30A/250V) required is the same as that of power cables. (One in the smallest
configuration; four in the largest configuration)
When changing the redundant configuration of the power module, make sure to contact
the reseller from which you have purchased the equipment.
WARNING
63