Set Weight - Dell S4810 Reference Manual

set weight

To add a non-RFC compliant attribute to the BGP route to assist with route selection, configure a filter.
S4810
Syntax
set weight weight
To delete a weight specification, use the no set weight weight command.
Parameters
weight
Defaults router-originated = 32768; all other routes = 0
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage If you do not use the set weight command, router-originated paths have a
Information
weight attribute of 32768 and all other paths have a weight attribute of zero.
294
Enter a number as the weight used by the route meeting the
route map specification. The range is from 0 to 65535. The
default is router-originated = 32768 and all other routes = 0.
When there are multiple routes to the same destination, the
routes with a higher weight are preferred.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Access Control Lists (ACL)