Defaults
Not configured.
Command
ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
set level
Commands
set metric
set metric-type
set tag
set comm-list delete
To remove the specified community list from the BGP route's COMMUNITY attribute, configure a filter.
S4810
Syntax
set comm-list community-list-name delete
To insert the community list into the COMMUNITY attribute, use the no set
comm-list community-list-name delete command.
Parameters
community-
list-name
Defaults
Not configured.
Command
ROUTE-MAP
Modes
284
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— specify the OSPF area for route redistribution.
— specify the metric value assigned to redistributed routes.
— specify the metric type assigned to redistributed routes.
— specify the tag assigned to redistributed routes.
Enter the name of an established Community list, up to 140
characters.
Access Control Lists (ACL)