show ip traffic
Example
This example shows how to display IP protocol information. In this case, the routing protocol is
RIP (Routing Information Protocol). For more information on configuring RIP parameters, refer to
"Configuring RIP" on page 21‐1:
Matrix>Router#show ip protocols
Routing Protocol is "rip"
Sending updates every 30 seconds
Next due in 19 seconds
Invalid after 180 seconds, hold down 120, flushed after 300
Incoming update filter list for all interfaces is not set
Outgoing update filter list for all interfaces is not set
Default Version Control:
Interface
Vlan
Vlan
Routing for Networks:
182.127.0.0
Routing Information Sources:
Gateway
Distance: (default is 1)
show ip traffic
Use this command to display IP traffic statistics.
Syntax
show ip traffic [softpath]
Parameters
softpath
Defaults
If softpath is not specified, general IP traffic statistics will be displayed.
Mode
Router command, Any router mode.
Example
This example shows how to display IP traffic statistics
Matrix>Router#show ip traffic
IP Statistics:
Rcvd:
Send
1
1
2
1
Distance
(Optional) Displays IP protocol softpath statistics. This option is used
for debugging.
10 total, 6 local destination 0 header errors
0 unknown protocol, 0 security failures
Recv
Key-chain
1
1
Last Update
Enterasys Matrix DFE-Gold Series Configuration Guide 16-23
Reviewing IP Traffic and Configuring Routes