Clear Spantree Version; Show Spantree Stpmode - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Bridge Parameters
mode will cause the bridge to transmit only 802.1D BPDUs, and will prevent non‐edge ports from
rapidly transitioning to forwarding state.
Example
This example shows how to globally change the Spanning Tree version from the default of MSTP
to RSTP:
Matrix(rw)->set spantree version rstp

clear spantree version

Use this command to reset the Spanning Tree version to MSTP mode.
Syntax
clear spantree version
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the Spanning Tree version:
Matrix(rw)->clear spantree version

show spantree stpmode

Use this command to display the Spanning Tree Protocol (STP) mode setting.
Syntax
show spantree stpmode
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
6-10 Spanning Tree Configuration
clear spantree version