set dot1x
set dot1x
Use this command to enable or disable 802.1X authentication, to reauthenticate one or more access
entities, or to reinitialize one or more supplicants.
Syntax
set dot1x {[enable | disable] [init | reauth [port-string] [index index-list]}
Parameters
enable | disable
init | reauth
port‐string
index index‐list
Defaults
If not specified, the reinitialization or reauthentication setting will be applied to all ports.
If index is not specified, all access entities will be affected.
Mode
Switch command, Read‐Write.
Examples
This example shows how to enable 802.1X:
Matrix(rw)->set dot1x enable
This example shows how to reinitialize fe.2.24:
Matrix(rw)->set dot1x init fe.2.24
set dot1x auth-config
Use this command to configure 802.1X authentication.
Syntax
set dot1x auth-config {[authcontrolled-portcontrol {auto | forced-auth | forced-
unauth}] [keytxenabled{false | true}] [maxreq value] [quietperiod value]
[reauthenabled {false | true}] [reauthperiod value] [servertimeout timeout]
[supptimeout timeout] [txperiod value]} [port-string]
Enables or disables 802.1X.
Reinitializes one or more access entities or reauthenticates one or more
supplicants.
(Optional) Specifies the port(s) to reinitialize or reauthenticate.
(Optional) Specifies one or more access entities on which to enable
initialization or reauthentication control. Valid values are 0 ‐ 8191.
Enterasys Matrix DFE-Gold Series Configuration Guide 25-7
Configuring 802.1X Authentication