Reviewing Ip Traffic And Configuring Routes; Purpose; Commands; Show Ip Route - Enterasys SecureStack B3 Configuration Manual

Example
This example show how to have all client DHCP requests for users in VLAN 1 to be forwarded to
the remote DHCP server with IP address 192.168.1.28.
B3(su)->router(Config)#interface vlan 1
B3(su)->router(Config-if(Vlan 1))#ip helper-address 192.168.1.28

Reviewing IP Traffic and Configuring Routes

Purpose

To review IP traffic and configure routes, to send router ICMP (ping) messages, and to execute
traceroute.

Commands

For information about...

show ip route

ip route
ping
traceroute
show ip route
Use this command to display information about IP routes.
Syntax
show ip route [connected | rip | static | summary]
Parameters
connected
rip
static
summary
Defaults
If no parameters are specified, all IP route information will be displayed.
Mode
Any router mode.
(Optional) Displays connected routes.
(Optional) Displays routes configured for the RIP routing protocol. For
details on configuring RIP, refer to "Configuring RIP" on page 18‐1.
(Optional) Displays static routes.
(Optional) Displays a summary of the IP routing table.
Reviewing IP Traffic and Configuring Routes
Refer to page...
17-13
17-14
17-15
17-15
SecureStack B3 Configuration Guide 17-13