clear logging application
clear logging application
Use this command to reset the logging severity level for one or all applications to the default value
of 6 (notifications of significant conditions).
Syntax
clear logging application {mnemonic | all}
Parameters
mnemonic | all
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the logging severity level for SSH:
Matrix(rw)->clear logging application SSH
show logging local
Use this command to display the state of message logging to the console and a persistent file.
Syntax
show logging local
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the state of message logging. In this case, logging to the
console is enabled and logging to a persistent file is disabled.
Matrix(rw)->show logging local
Syslog Console Logging enabled
Syslog File Logging disabled
(Optional) Resets the severity level for a specific application or for all
applications. Valid mnemonic values and their corresponding
applications are listed in Table
Enterasys Matrix DFE-Gold Series Configuration Guide 10-11
Configuring System Logging
10‐3.