Clear Multiauth Session-Timeout; Set Multiauth Trap - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Multiple Authentication

clear multiauth session-timeout

Use this command to clear session‐timeout values, for one or all authentication methods, back to
the default values.
Syntax
clear multiauth session-timeout [cep | dot1x | mac | pwa]
Parameters
cep
dot1x
mac
pwa
Defaults
If no authentication type is specified, the session timeout value is returned to 300 seconds for all
authentication types.
Mode
Switch command, Read‐Write.
Examples
This example shows how to clear the session‐timeout values, for an active session, for cep and mac
authentication types, to the default value of 0 seconds:
Matrix(rw)->clear multiauth idle-timeout cep
Matrix(rw)->clear multiauth idle-timeout mac
This example shows how to clear the session‐timeout values, for an active session, for all
authentication types, to the default value of 0 seconds:
Matrix(rw)->set multiauth idle-timeout

set multiauth trap

Use this command to set the multiauth trap setting for system, module and port.
Syntax
set multiauth trap {system {enabled | disabled} | module {enabled | disabled} |
port portstring {all | success | failed | terminated | max-reached}}
27-14 MultiAuth Configuration
(Optional) Specifies the authentication type Enterasys Convergence
End Point Authentication.
(Optional) Specifies the authentication type IEEE 802.1X Port‐Based
Network Access Control.
(Optional) Specifies the authentication type Enterasys Mac
Authentication.
(Optional) Specifies the authentication type Enterasys Port Web
Authentication.
clear multiauth session-timeout