Configuring Convergence End Points (CEP) Phone Detection
set cep detection-id address
Use this command to set an H.323, Siemens, or SIP phone detection group's IP address or mask.
Syntax
set cep detection-id id address { ip-address | unknown }
mask {mask | unknown }
Parameters
id
address ip‐address |
unknown
mask mask |
unknown
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
This command applies only to Siemens, H.323, and SIP phone detection. Cisco detection uses
CiscoDP as its discovery method.
By default, H.323 will use 224.0.1.41 as its IP address and Siemens will have no IP address
configured.
Example
This example shows how to set an IP address of 10.1.1.3 and mask for detection group 1:
Matrix>set cep detection-id 1 address 10.1.1.3 mask 255.255.0.0
set cep detection-id protocol
Use this command to specify an IP protocol type for H.323, Siemens, or SIP convergence end
points detection.
Syntax
set cep detection-id id protocol {tcp | udp | both | none}
25-46 Authentication Configuration
Specifies a CEP configuration group ID. This group must be created
and enabled using the set cep detection‐id command as described in
"set cep detection‐id" on page 25‐44. Valid values are 1 ‐ 2147483647.
Sets the IP address for CEP detection, or sets the address to unknown.
Set the IP mask for CEP detection, or sets the mask to unknown.
set cep detection-id address