show ip route
Example
This example shows how to clear all IP traffic counters:
Matrix>Router#clear ip stats
show ip route
Use this command to display information about IP routes.
Syntax
show ip route [destination prefix destination prefix mask longer-prefixes |
connected | ospf | rip | static | summary]
Parameters
destination prefix
destination prefix mask
longer‐prefixes
connected
ospf
rip
static
summary
Defaults
If no parameters are specified, all IP route information will be displayed.
Mode
Router command, Any router mode.
Usage
When there is more than one routing module configured in an Enterasys Matrix chassis, each
module will create and maintain its own route tables.
Routes are managed by the RTM (Route Table Manager), and are contained in the RIB (Route
Information Base). This database contains all the active static routes, all the RIP routes, and up to
three best routes to each network as determined by OSPF.
The RTM selects up to three of the best routes to each network and installs these routes in the FIB
(Forwarding Information Base). The routes in the FIB are distributed to every module for use by
the routerʹs distributed forwarding engine on the ingress module as frames are received.
(Optional) Converts the specified address and mask into a prefix and
displays any routes that match the prefix.
(Optional) Displays connected routes.
(Optional) Displays routes configured for the OSPF routing protocol.
For details on configuring OSPF, refer to "Configuring OSPF" on
page 21‐19.
(Optional) Displays routes configured for the RIP routing protocol. For
details on configuring RIP, refer to "Configuring RIP" on page 21‐1.
(Optional) Displays static routes.
(Optional) Displays a summary of the IP routing table.
Enterasys Matrix DFE-Gold Series Configuration Guide 16-25
Reviewing IP Traffic and Configuring Routes