show spantree backuproottrapendable
Example
This example shows how to reset the backup root function to disabled on SID 2:
Matrix(rw)->clear spantree backuproot 2
show spantree backuproottrapendable
Use this command to display the state of the Spanning Tree backup root trap function.
Syntax
show spantree backuproottrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the status of the backup root trap function:
Matrix(rw)->show spantree backuproottrapenable
Backup Root Trap is set to enable
set spantree backuproottrapenable
Use this command to enable or disable the Spanning Tree backup root trap function.
Syntax
set spantree backuproottrapenable {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
When SNMP trap messageing is configured, this sends a trap message when the back up root
function makes a Spanning Tree the new root of the network.
Enables or disables the backup root trap function.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-43
Configuring Spanning Tree Bridge Parameters