Configuring LACP
Example
This example shows how to display the status of the single port LAG function:
Matrix(rw)->show lacp singleportlag
Single Port LAGs:
set singleportlag
Use this command to enable or disable the formation of single port LAGs. When enabled, this
maintains LAGs when only one port is receiving protocol transmissions from a partner.
Syntax
set lacp singleportlag {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to enable single port LAGs:
Matrix(rw)->set lacp singleportlag enable
clear singleportlag
Use this command to reset the single port LAG function back to the default state of disabled.
Syntax
clear lacp singleportlag
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the single port LAG function back to disabled:
Matrix(rw)->clear lacp singleportlag
4-64 Port Configuration
enabled
Enables or disables the formation of single port LAGs.
set singleportlag