Configuring the VLAN Egress List
Example
This example shows you how to show VLAN egress information for Fast Ethernet ports 1 through
3 in module 1. In this case, all three ports are allowed to transmit VLAN 1 frames as tagged and
VLAN 10 frames as untagged. Both are static VLANs:
Matrix(rw)->show port egress fe.1.1-3
Port
Number
-------------------------------------------------------
fe.1.1
fe.1.1
fe.1.2
fe.1.2
fe.1.3
fe.1.3
set vlan egress
Use this command to add ports to the VLAN egress list for the device, or to prevent one or more
ports from participating in a VLAN. This determines which ports will transmit frames for a
particular VLAN.
Syntax
set vlan egress vlan-list port-string [untagged | forbidden | tagged]
Parameters
vlan‐list
port‐string
untagged | forbidden
| tagged
Defaults
If untagged, forbidden or tagged is not specified, the port will be added to the VLAN egress list
as tagged.
Mode
Switch command, Read‐Write.
7-18 802.1Q VLAN Configuration
Vlan
Egress
Id
Status
1
tagged
10
untagged
1
tagged
10
untagged
1
tagged
10
untagged
Specifies the VLAN where a port(s) will be added to the egress list.
Specifies one or more ports to add to the VLAN egress list of the
specified vlan‐list. For a detailed description of possible port‐string
values, refer to "Port String Syntax Used in the CLI" on page 4‐2.
(Optional) Adds the specified ports as:
•
untagged — Causes the port(s) to transmit frames without an IEEE
802.1Q header tag.
•
forbidden — Instructs the device to ignore dynamic requests
(either through GVRP or dynamic egress) from the port(s) to join
the VLAN and disallows egress on that port.
•
tagged — Causes the port(s) to transmit 802.1Q tagged frames.
Registration
Status
static
static
static
static
static
static
set vlan egress