clear port ratelimit
priority
threshold
inbound
index
Defaults
•
If not specified, threshold will be applied to inbound traffic on the port/priority.
•
If index is not specified, settings will be applied to index 1, and will overwrite index 1 for any
subsequent rate limits configured.
Mode
Switch command, Read‐Write.
Example
This example shows how to:
•
globally enable rate limiting
•
configure rate limiting for inbound traffic on port fe.2.1, index 1, priority 5, to a threshold of
125 KBps:
Matrix(rw)->set port ratelimit enable
Matrix(rw)->set port ratelimit fe.2.1 5 125 enable inbound
clear port ratelimit
Use this command to clear rate limiting parameters for one or more ports.
Syntax
clear port ratelimit port-string [index]
Parameters
port‐string
index
Defaults
If not specified, all index entries will be reset.
Mode
Switch command, Read‐Write.
Specifies the 802.1D (802.1p) port priority level associated with the port‐
string. Options are:
•
0 ‐ 7, with 0 specifying the lowest priority, and
•
all to set the rate limiting threshold and other parameters on all
port priority levels associated with the port‐string.
Specifies a port rate limiting threshold in kilobytes per second. Range is
64 up to the maximum bytes per second rate for a given interface.
(Optional) Applies this rate policing rule to inbound or outbound
traffic.
(Optional) Assigns a resource index for this port.
Specifies the port(s) on which to clear rate limiting. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
(Optional) Specifies the associated resource index to be reset.
Enterasys Matrix DFE-Gold Series Configuration Guide 22-11
Configuring Port Traffic Rate Limiting